The cable is the most-specified and least-considered component in the room. It is also the most common cause of an installation that passes in the lab and struggles on site. The physics are simple; the specification discipline is what matters.
A resolution number alone describes very little. 4K at 60Hz with 4:2:0 chroma subsampling and 8-bit colour requires roughly 9 Gbps. The same resolution at 4:4:4 and 8-bit requires around 18 Gbps, the ceiling of HDMI 2.0; 10-bit 4:4:4 at 4K60 needs more than that. 8K at 60Hz pushes past 40 Gbps and depends on Fixed Rate Link signalling introduced with HDMI 2.1.
Specify the cable to the bandwidth the source will actually produce, at the colour depth the room requires. A cable rated for 18 Gbps carries 4K60 4:4:4 comfortably and carries 8K not at all.
Passive HDMI cable attenuates. At 18 Gbps, well-constructed passive copper is reliable to roughly five metres; beyond that, margin evaporates and intermittent faults appear — sparkles, dropouts, or a handshake that fails on a cold boot.
At 48 Gbps the budget shortens further. For any 8K run beyond approximately three metres, active optical cable is the correct specification, not an upgrade.
An AOC converts the electrical signal to light at the source end and back at the display end. It carries full bandwidth over tens of metres with no attenuation penalty, and it is immune to the electromagnetic environment of a busy rack.
AOC is directional. The source end and display end are marked, and reversing them yields no picture. This is worth noting in the installation drawing, because it is discovered otherwise at the least convenient moment.
HDBaseT reach is rated per product, for a stated format over a stated cable class, and the two are read together: every TELECIS extender states its distance with the format and the cable it is rated on. CAT5e is the minimum cable HDBaseT was designed for; for new installations, specify CAT6A — U/FTP where the product or the HDBaseT generation recommends it — for margin over the life of the cable.
Every figure assumes solid-core cable, correctly terminated, with as few connection points as possible. Stranded patch cable adds loss, each patch point spends margin, and inline couplers do not belong in the run; near-limit runs are terminated directly. On screened cable, use shielded jacks and plugs and bond the screen as the cabling system requires. Certify each run to its category, then commission the link at the room's real format.
Why each figure carries its conditions: what an HDBaseT reach figure assumes.
| Signal | Approximate bandwidth |
|---|---|
| 1080p60, 8-bit | ~4.5 Gbps |
| 4K60, 4:2:0, 8-bit | ~9 Gbps |
| 4K60, 4:4:4, 8-bit | ~18 Gbps |
| 8K60, 4:2:0, 10-bit | ~40 Gbps |
Send the room and the constraints. We return the architecture, the bill of materials, and the route to supply.