Home›Products›Cables›HDMI AOC Cable (8K)
TC-AOC-HDMI-8K

HDMI AOC Cable (8K)

Native 8K @ 60Hz and 4K @ 120Hz, 48 Gbps

TC-AOC-HDMI-8K

TC-AOC-HDMI-8K is an active optical HDMI cable for the runs copper cannot make: the full 48 Gbps HDMI signal carried over fibre — up to 8K @ 60Hz 4:4:4, or 4K @ 120Hz — carrying HDCP 2.3-protected content end to end. Up to 20 m, length stops being the constraint on the format.

Optical transport picks up no interference along the route and needs no equalisation at the far end; the cable is slim and light enough to pull like data cable. Standard HDMI plugs at both ends carry the electronics — the cable is directional, with source and display ends marked.

  • Native 8K @ 60Hz and 4K @ 120Hz, 48 Gbps
A
Specifications

The section that earns
the premium.

ParameterSpecification
HDCPPasses HDCP 2.3-protected signals
Maximum resolutionUp to 8K @ 60 Hz 4:4:4 · 8K @ 30 Hz · 4K @ 120 Hz
BandwidthUp to 48 Gbps
Colour depth8/10/12-bit — resolution, refresh rate and depth together within 48 Gbps
HDRHDR10, HDR10+, Dolby Vision, HLG pass-through
CECCEC supported
HDMI audio formatsLPCM (8-channel, 192 kHz / 24-bit), Dolby TrueHD, DTS-HD Master Audio, DSD
ConnectorsHDMI Type A male at both ends · directional — Source end to the source, Display end to the display
Power supplyNo external power
Operating temperature0 to 40 °C
Storage temperature−20 to 60 °C
HumidityOperating 20–80 % · storage 10–90 % RH, non-condensing
ESD protection±8 kV air · ±4 kV contact (IEC 61000-4-2)
Cable constructionOptical fibre + tinned-copper hybrid · 4.8 mm OD · PVC jacket · metal connector shells, gold-plated
Installation limitsPull no more than 10 kg · hold the connector body, never the cable
ComplianceDesigned for global compliance — CE, FCC, RoHS, and regional certifications, as applicable.
Warranty3 years
Available lengths10 m TC-AOC-HDMI-8K-10 · 15 m TC-AOC-HDMI-8K-15 · 20 m TC-AOC-HDMI-8K-20
Every value above is taken from the manufacturer's documentation for this model and matches the TELECIS datasheet. Subject to change without notice.
Specification text for consultants8 clauses · basis of design

Basis of design: TELECIS TC-AOC-HDMI-8K.

  1. General The cable shall be HDMI Type A male at both ends, directional (Source end to the source, Display end to the display), in 10, 15 or 20 m lengths, with no external power.
  2. Video The cable shall carry up to 48 Gbps, passing HDCP 2.3-protected signals: up to 8K @ 60 Hz 4:4:4, 8K @ 30 Hz and 4K @ 120 Hz, with HDR10, HDR10+, Dolby Vision and HLG pass-through, and CEC.
  3. Colour The cable shall support deep colour up to 12-bit (8/10/12-bit), with resolution, refresh rate and depth together within 48 Gbps.
  4. Features The cable shall support VRR, ALLM, QMS, QFT and SBTM.
  5. Audio The cable shall carry LPCM (8-channel, 192 kHz / 24-bit), Dolby TrueHD, DTS-HD Master Audio and DSD.
  6. Physical The cable shall be an optical fibre + tinned-copper hybrid, 4.8 mm OD, with a PVC jacket and gold-plated metal connector shells.
  7. Installation The cable shall be pulled with no more than 10 kg, holding the connector body, never the cable.
  8. Environmental The cable shall operate at 0 to 40 °C and 20–80 % RH, non-condensing, and be stored at −20 to 60 °C.

Written to paste into a project specification; every clause is taken from the manufacturer's documentation behind this page. Check the datasheet revision before issue.

B
Documents

Engineering documentation,
plainly accessible.

C
Within the family

Specified as a system.

D
Specifying this model

Where it belongs.

Copper stops being the right answer sooner than most drawings assume. This active optical HDMI assembly carries the highest formats over a run that a passive cable could not hold, which is what makes it the connection into a room for a high-bandwidth source — and the reason the last metre should be specified as carefully as the first.

Active optical cables are directional. Confirm the source end before the cable is pulled, and pull it without kinking.
Specifying for a project?

Where to buy.

TELECIS is sold through authorised regional partners, and directly by the TELECIS specification desk where no partner is appointed. Write with the model and the project.