Home›Support›Knowledge Base›Audio Routing
Audio Routing

Dante for AV integrators — clocking, latency, and routing discipline

Dante moves multichannel audio across an ordinary Ethernet network with sample-accurate synchronisation. For the integrator it removes analogue cable runs and gives the commissioning engineer a routing matrix in software. It also introduces a clock, and the clock is the thing to understand.

AUDIO

One clock, many devices

Every Dante device on a network derives its sample clock from a single elected clock master, using Precision Time Protocol. Synchronisation is sample-accurate, which is what allows channels arriving from different devices to be summed without artefacts.

Election is automatic, and it is worth making it deliberate. Designate a stable, always-powered device — typically a DSP — as preferred master. A network whose clock master is a laptop that leaves the building at six o'clock will behave accordingly.

Latency is a setting, not an accident

Dante devices declare a latency budget, commonly between 0.25 ms and 5 ms. The value must accommodate the number of switch hops between transmitter and receiver: each hop adds delay, and a budget set too tightly produces dropouts under load.

Set the budget from the network topology, verify it under realistic traffic, and record it in the commissioning documentation. One millisecond is comfortable for most rooms in a single switch.

Routing, subscriptions, and the estate

A receiver subscribes to a transmitter's channel. The subscription persists in the device, which means a room recovers its own routing after a power cycle without a controller present.

Name devices and channels for the room and the function rather than the model number. A commissioning engineer returning in three years reads names, not serial numbers.

Where TELECIS sits in the audio path

The TELECIS Dante line converters work on the same fabric, with Class-D amplifiers and a Dante audio processor announced — so the video switch and the audio fabric are configured as one system rather than integrated after the fact.

Amplification on the same fabric closes the path: programme audio arrives at the amplifier over the network with the same clock, and the analogue domain begins at the loudspeaker terminal.

Design decisionRecommended practice
Clock masterDesignate a stable, always-powered device as preferred master
Latency budgetSet from switch-hop count; 1 ms suits most single-switch rooms
VLANSeparate AV audio from corporate traffic; enable QoS
NamingName by room and function, never by model
REF
Referenced in this article

Specified as a system.

Specifying for a project?

Specifying with this in mind?

Send the room and the constraints. We return the architecture, the bill of materials, and the route to supply.