Home›Products›Cables›Full-featured Type-C Active Optical Cable
TC-AOC-USBC

Full-featured Type-C Active Optical Cable

Full-featured USB-C: video, data, and power in one connector

TC-AOC-USBC

TC-AOC-USBC is a full-featured USB-C active optical cable: DisplayPort Alt Mode video and high-speed USB data carried over fibre, with the low-speed signals and power on copper, for the desk-to-display and desk-to-hub runs that passive copper cannot reach.

One connector for the presenter and one pull for the integrator, immune to interference along the way — the single-cable room, extended to the length the room actually is.

  • Full-featured USB-C: video, data, and power in one connector
A
Specifications

The section that earns
the premium.

ParameterSpecification
Signal standardDisplayPort 1.4 Alt Mode — 4-lane or 2-lane, switched automatically
Maximum resolution4-lane mode: 8K @ 60 Hz, 4K @ 144 / 120 Hz · 2-lane mode: 4K @ 60 Hz
USBUSB 3.2 Gen 2 (10 Gbps) in 2-lane mode · USB 2.0 in 4-lane mode · backward compatible with USB 2.0 / 1.1
ConnectorsUSB-C male to USB-C male · directional — Source end to the computer, Display end to the screen
Power supplyNo external power · working voltage 5 V ± 0.25 V · charging power from the display or dock passes through
Operating temperature0 to 40 °C
Storage temperature−20 to 60 °C
HumidityOperating 20–80 % · storage 10–90 % RH, non-condensing
ESD protection±8 kV air · ±4 kV contact (IEC 61000-4-2)
Cable constructionOptical fibre + tinned-copper hybrid · 850 nm · 6.5 mm OD · PVC jacket · metal connector shells, nickel-plated
ChargingUSB PD 3.0, 20 V / 5 A — up to 85 W at 10 m, from the display or dock, passed through by the cable
Installation limitsPull no more than 10 kg · hold the connector body, never the cable
ComplianceDesigned for global compliance — CE, FCC, RoHS, and regional certifications, as applicable.
Warranty3 years
Available lengths10 m TC-AOC-USBC-10
Every value above is taken from the manufacturer's documentation for this model and matches the TELECIS datasheet. Subject to change without notice.
Specification text for consultants7 clauses · basis of design

Basis of design: TELECIS TC-AOC-USBC.

  1. General The cable shall be USB-C male to USB-C male, directional (Source end to the computer, Display end to the screen), 10 m long, with an E-Mark chip.
  2. Video The cable shall carry DisplayPort Alt Mode video, 4-lane or 2-lane, switched automatically: 8K @ 60 Hz and 4K @ 144 / 120 Hz in 4-lane mode, 4K @ 60 Hz in 2-lane mode.
  3. USB The cable shall carry USB data at 10 Gbps in 2-lane mode and USB 2.0 in 4-lane mode, backward compatible with USB 2.0 / 1.1, and support touch feedback, so a touch display works in conjunction with the source.
  4. Power The cable shall need no external power (working voltage 5 V ± 0.25 V), and shall pass USB PD charging from the display or dock through to the computer.
  5. Physical The cable shall be an optical fibre + tinned-copper hybrid (850 nm), 6.5 mm OD, with a PVC jacket and nickel-plated metal connector shells.
  6. Installation The cable shall be pulled with no more than 10 kg, holding the connector body, never the cable.
  7. Environmental The cable shall operate at 0 to 40 °C and 20–80 % RH, non-condensing, and be stored at −20 to 60 °C.

Written to paste into a project specification; every clause is taken from the manufacturer's documentation behind this page. Check the datasheet revision before issue.

B
Documents

Engineering documentation,
plainly accessible.

C
Within the family

Specified as a system.

D
Specifying this model

Where it belongs.

One connector carrying three contracts — video, data and power — over a length where a passive lead would already have failed. This is the cable for the table in a USB-C room: the guest laptop presents and takes the room's peripherals without a dock in the middle of the path.

Confirm what the cable must carry — video, data and charging are separate expectations of the same connector.
Specifying for a project?

Where to buy.

TELECIS is sold through authorised regional partners, and directly by the TELECIS specification desk where no partner is appointed. Write with the model and the project.