Home›Support›Knowledge Base›Troubleshooting
Troubleshooting

Troubleshooting a signal fault — a diagnostic order that isolates fast

Most signal faults resolve to one of a small number of causes. Working the layers in order — physical, then link, then negotiation, then content protection — isolates the fault in minutes rather than an afternoon.

SUPPORT

No image at all

Confirm the source is producing signal by connecting it directly to a known-good display with a known-good short cable. This single test separates a source fault from a system fault.

If direct connection works, reintroduce the system one element at a time. Confirm the matrix reports the input as present in its web interface. Confirm the route is set. Confirm the output port is enabled. A route that is set but shows no signal points at EDID or HDCP; a route the matrix reports as absent points at the cable.

Intermittent image — sparkles, dropouts, cold-boot failures

Intermittent behaviour at high bandwidth is almost always marginal physical layer. Substitute a shorter or active optical cable on the failing run. If the fault clears, the original cable lacked headroom for the format in use, even when it is rated for it on paper.

A system that works warm and fails cold is a handshake with insufficient margin. Verify HDCP version negotiation on the failing output and check repeater depth in cascaded designs.

Wrong resolution, or a display showing an unexpected format

This is EDID. Read the active EDID block for the input from the matrix's web interface, and compare it against the display's capabilities. Where the room mixes display types, move from copy-from-output to an internal library profile so the source is told a format every destination accepts, then scale per output.

Where a single display misbehaves, its published EDID may be incomplete. A custom uploaded block resolves this deterministically.

Audio present on one path and absent on another

Confirm the audio format the source is transmitting is one the destination accepts. A source emitting bitstream Dolby TrueHD into a device expecting two-channel PCM produces silence, correctly.

For Dante paths, confirm the subscription is active, the clock master is present, and the latency budget accommodates the switch hops in use. For ARC and eARC paths, confirm the display's own ARC port is the one connected, since displays commonly carry the function on a single specific HDMI port.

SymptomFirst test
No image, any outputSource direct to display, short known-good cable
Intermittent, high bandwidthSubstitute active optical cable on the failing run
Unexpected resolutionRead the active EDID block for that input
Black screen, protected content onlyVerify HDCP version and repeater depth
Audio absentConfirm format compatibility, then subscription and clock
REF
Referenced in this article

Specified as a system.

Specifying for a project?

Specifying with this in mind?

Send the room and the constraints. We return the architecture, the bill of materials, and the route to supply.