Home›Support›Knowledge Base›HDCP Handshaking
HDCP Handshaking

HDCP 2.3, repeaters, and why the handshake matters in routed systems

High-bandwidth Digital Content Protection is the reason a perfectly good display sometimes shows a black screen. Understanding the authentication chain — and specifying products that manage it correctly — removes an entire class of commissioning problems.

SIGNAL FUNDAMENTALS

The handshake, in order

When a protected source connects to a display, the two devices authenticate. The source verifies the display holds valid keys, exchanges a session key, and only then transmits encrypted video. The display decrypts and renders. Any device between them must participate.

A matrix sits in that chain. It authenticates downstream as a receiver to the source, and upstream as a transmitter to each display. A device that does this correctly is called a repeater, and its behaviour under load is what separates professional infrastructure from consumer hardware.

Version negotiation, and why 2.3 matters

HDCP 2.3 is the current revision, required for 4K and 8K protected content from most commercial sources. It is backward-compatible: a 2.3 matrix negotiates down to 2.2 or 1.4 when a downstream display requires it, and TELECIS routing products perform this negotiation automatically.

The practical consequence is mixed estates work. An 8K matrix feeding a modern display and a legacy 1080p confidence monitor authenticates each output at the highest version that output supports, rather than forcing the whole system to the lowest.

Key counts and topology limits

HDCP defines a maximum number of downstream devices and a maximum repeater depth. Exceeding either causes authentication to fail across the system — often intermittently, which makes it difficult to diagnose.

In practice, this constrains cascaded designs: a matrix feeding splitters feeding displays adds repeater levels quickly. Where a design approaches the limit, an AV-over-IP architecture removes the constraint entirely, because each endpoint authenticates independently.

Specifying for a clean authentication

Use HDCP-compliant cable throughout; the DDC lines carry the handshake and a marginal cable fails the handshake before it fails the video. Confirm every source's protection requirement at design time. Where a source outputs protected content and a destination is a recorder, plan the signal path accordingly. And favour architectures that keep repeater depth shallow.

HDCP versionTypical requirement
HDCP 2.34K and 8K protected content from current commercial and streaming sources.
HDCP 2.24K protected content from earlier-generation sources and media players.
HDCP 1.41080p protected content; legacy sources and displays.
REF
Referenced in this article

Specified as a system.

Specifying for a project?

Specifying with this in mind?

Send the room and the constraints. We return the architecture, the bill of materials, and the route to supply.